Here are installation instructions for our cubicle plexiglass shield mounting clamps. You can buy them by clicking here.

Items Required for one (1) divider piece:

• Two (2) pair of HM AO 1/4” Panel Clamps
• Two (2) 8-32 x 5/16 black Phillips head screws
• Four (4) foam stickers
• One (1) Phillips head screw driver
• One (1) Divider with 3/8” diameter holes 3/4” from base

Step One:

• Arrange clamp halves together for easy install
• Remove foam stickers from paper backing
• Place one (1) each on the upper inside half of clamps

Step Two:

• Fit screw hole side of clamp into 3/8” holes in the divider, making sure the screw hole can rotate freely inside holes in divider

Step Three:

• Loosely assemble the clamps, tightening the screw only a thread or two into the screw hole

Step Four:

• Fit assembly onto the Herman Miller Action Office Panel, loosening the assembly as needed until the clamps sit as shown above

Step Five:

• Adjust the assembly to desired location on the top cap and tighten clamps with the Phillips head screwdriver until secure

Please contact us if you have any questions.

Thank you.